Used Robots.com: Panasonic G Instruction Manual

7 - 6 7-4. Connection work for a 3-phase, 200 VAC type (1) Connect the primary power cable (Refer to Section 7-1)
(2) Open the rear side door by unlocking fasteners with keys (which fasten        the rear side door to the controller cover) provided two each at the back of
       both (right and left) sides.
(3) Switch the connection of the primary harness connector “200 V” of the transformer (UTU5269   ) from the connector “200 V” to the connector
“220 V” on the power card (ZUEP5551   ). Harness connector
(200 V) Connector (220 V) Connector (200 V) Power card
ZUEP5551 Transformer
UTU5269


\| 1 \| 2 \| 3 \| 4 \| 5 \| 6 \| 7 \| 8 \| 9 \| 10 \| 11 \| 12 \| 13 \| 14 \| 15 \| 16 \| 17 \| 18 \| 19 \| 20 \| 21 \| 22 \| 23 \| 24 \| 25 \| 26 \| 27 \| 28 \| 29 \| 30 \| 31 \| 32 \| 33 \| 34 \| 35 \| 36 \| 37 \| 38 \| 39 \| 40 \| 41 \| 42 \| 43 \| 44 \| 45 \| 46 \| 47 \| 48 \| 49 \| 50 \| 51 \| 52 \| 53 \| 54 \| 55 \| 56 \| 57 \| 58 \| 59 \| 60 \| 61 \| 62 \| 63 \| 64 \| 65 \| 66 \| 67 \| 68 \| 69 \| 70 \| 71 \| 72 \|

Contact Us \| Robotics Education \| Site Map \| Articles \| Robot Manuals \| Disclaimer \| Links Worldwide