−1−4−WarningObserve the following cautions to prevent accidents that can cause serious injuries.1. Never touch any charging part. 2. Grounding work of peripheral equipment and jigs of the robot case andsystem shall be performed by a qualified person (in electric work) according to related regulations (electric installation technique) of the relevant country.3. Be sure to turn off the power switch at the power distribution box to shutdown input power to the robot system or any associated equipment, and leave it for at least five (5) minutes before performing installation or maintenance and inspection work. Since turning off the input power may not discharge the capacitor completely, check the capacitor for residual voltage before the work.4. Cables to be applied shall have sufficient ampare capacity and be free fromdamages (no breaking wire or bare wire is applicable).5. Cable shall be connected completely and insulated without fail. 6. Never operate the robot with the case or cover removed. 7. Periodical maintenance and inspection work shall be performed. Repair anydamaged part if found.8. Be sure to shut down all input power to the robot system and any associatedequipment if the system is not in use.CautionObserve the following cautions to prevent accidents which may be caused by any of the rotating parts.1. Do not operate the robot with the case or cover removed. 2. If it is necessary to remove the case for maintenance and inspection orrepair work, it must be performed by operators who are qualified or who understand the robot thoroughly. Never allow a person to get close to the equipment unless necessary.3. Do not bring hands, fingers, hair or clothes near the cooling fan or any rotating parts.*Touch to any charging part may result in fatal electrical shock or heat inury.*Do not bring hands, fingers, hair or clothes near the cooling fan or any rotating parts to prevent part of your body or clothing to be taught by such rotating part of the machine.