Used Robots.com: Motoman XRC Installation and Wiring

Created: 99-03-25 Revised: 00-11-13 Maintenance manual MOTOMAN XRC Page: 81 Connect to XEW01-board MOTOMAN ROBOTICS EUROPE 6.11 Connect to XEW01-board As option, welding interface (XEW01) can be installed in the bus link. Maximum
three boards can be mounted.
At the welding interface board, three analogue outputs can be connected to con-
trol wire feeding, etc.
The XEW01-board can be used for other applications, where analogue signals
are used.
The board can be set to both 16 and 17 bit. JANCD-
XEW01- 1 REV. 0 0 C CN04 F1 F2 CN03 CN02 S1 CN01 Jumper, SW1, mounted on
the board Switch between;
17 byte and 16 byte
Note! Always set to 16 bit Power IN Power OUT Bus link IN/OUT S1, Switch for address setting of
the board. See separate chapter
for more information. Fig.29 Analogue board, type
JANCD-XEW01-1


\| 1 \| 2 \| 3 \| 4 \| 5 \| 6 \| 7 \| 8 \| 9 \| 10 \| 11 \| 12 \| 13 \| 14 \| 15 \| 16 \| 17 \| 18 \| 19 \| 20 \| 21 \| 22 \| 23 \| 24 \| 25 \| 26 \| 27 \| 28 \| 29 \| 30 \| 31 \| 32 \| 33 \| 34 \| 35 \| 36 \| 37 \| 38 \| 39 \| 40 \| 41 \| 42 \| 43 \| 44 \| 45 \| 46 \| 47 \| 48 \| 49 \| 50 \| 51 \| 52 \| 53 \| 54 \| 55 \| 56 \| 57 \| 58 \| 59 \| 60 \| 61 \| 62 \| 63 \| 64 \| 65 \| 66 \| 67 \| 68 \| 69 \| 70 \| 71 \| 72 \| 73 \| 74 \| 75 \| 76 \| 77 \| 78 \| 79 \| 80 \| 81 \| 82 \| 83 \| 84 \| 85 \| 86 \| 87 \| 88 \| 89 \| 90 \| 91 \| 92 \| 93 \| 94 \| 95 \| 96 \| 97 \| 98 \| 99 \| 100 \| 101 \| 102 \| 103 \| 104 \| 105 \| 106 \| 107 \| 108 \| 109 \| 110 \| 111 \| 112 \| 113 \| 114 \| 115 \| 116 \| 117 \| 118 \| 119 \| 120 \| 121 \| 122 \|

Contact Us \| Robotics Education \| Site Map \| Articles \| Robot Manuals \| Disclaimer \| Links Worldwide